Let’s connect your NavTool device.
Connect the device to this computer with USB. Chrome or Edge will ask you to select it.
No software installation is required.
How can we help?
Device controls
Video input
Vehicle events
Choose your vehicle
Please keep this page open.
Configure your camera inputs
Choose how each input is used. The same options apply to rear, front, left, and right cameras.
If these settings are already correct, continue without changing or saving anything.
Make it work your way
Optional preferences for your installation. Review the wiring instructions before changing the reverse trigger.
Adjust the image on your screen
Use the calibration pattern on the vehicle screen. Each press changes the image by one step; current numeric values are not available from the device.
Position, size, and termination changes appear immediately but are temporary until you save them. Restoring factory defaults restarts the device.
Keep USB connected while reading or saving settings. In bootloader mode, vehicle power and a restart are not required. Keep the vehicle parked while configuring the device.
Request a technician
Press Request remote support when you are ready.
USB device disconnected
- Unplug and firmly reconnect the USB cable.
- Wait a few seconds while this page reconnects automatically.
- If it does not reconnect, press the button below and select CAR_INTERFACE.
Your technician session will remain open.
Scan with your phone
- Open the Camera app on your phone.
- Point it at this QR code and open the link.
- On your phone, press Start camera and allow access.
This one-time code expires in five minutes.